Buildapc

3803 readers

19 users here now

founded 1 year ago

MODERATORS

[email protected]

Display issue (lemmy.world)

submitted 9 months ago by [email protected] to c/[email protected]

31 comments fedilink hide all child comments

I finished building my PC recently. when I turn on the monitor when the computer isn't on, there's obviously no signal and I see the bouncing logo, but when the computer is on, it says that there is no signal, and that my monitor is going into standby mode, and the display turns off. my gpu seems to be working fine, and I reseated my ram. What should I do?

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 1 points 9 months ago* (last edited 9 months ago) (1 children)

Do you have a second monitor to test on the computer? A second computer to test on the monitor?

Try to verify each component works with known good systems. Try a different cable. Try plugging into different ports on the GPU.

Does the Motherboard give you any bios beep codes? Or show a error on a bios display?

Is the display set to the right input method? (display port, vs hdmi, vs usb-c, etc)

Does the keyboard caps lock light go on and off during boot?

You could try putting in only one stick of ram, swapping out video cards, using the onboard display output (if you have it), reseating the CPU, double checking the power supply is tightly connect to all the correct ports on the GPU, and motherboard.

[–] [email protected] 1 points 9 months ago

I've tried both HDMI and dp on the GPU. I haven't been able to check the bios since I don't have any display. I tested it on my Mac and the monitor is fine