This to shall pass, a grind?
Mpatch
Thanks! Wow that car was flattened pretty damn good
Gifs that end to soon
Nah my cast only washes with hot water and small Scraper. If you need soap. We'll you don't like actualy don't. Seasoning? Just cook bacon, dump the grease leave a bit in put it back on the stove for a hot minute or while you put your blt together. Done it's hunk of metal not much you can do to fuck it up. And if food is sticking to it probably cause you didn't get the pan hot enough before you put the food in.
Oy yah i Rember the Repunzle tutorial.
I've been using a 1/4" thick sheet of carbon fiber for years now. Once warmed up to temp prints stick hard on it. As soon as it's cool a breeze can push a print of the bed. Plus it won't shatter like glass does eventually, boy was that a surprise. You still have to wipe clean with some rubbing alcohol before printing.
Bad bearing on a moving part. Or a bur along a rail, It catches just enough to cause the smooth motion to jitter a bit as the head moves along. Blobbing the material down instead of spreading it nice and even.
You have a draft going through your room, I used to have same issue when my printer was beside a window. Less when I moved the printer to middle of the room and issue was gone when put the printer into a closet. With closed doors.
You can try lowering bed temperature to, the warm bed keeps lower layer pliable but the upper layers cool and contract pulling the more flexible layer up and away. So a cooler bed temp should make the bottom layers more ridgid.
You are a fucking monster. The point of this was to have some laughs not cause a poor walmart employee to beat their spouse or off them selves. Damn you're cruel.
Apart from the preeety picture, are there any actual problems with the motor? If not just drive it. Add zunc additive to every oil change from now on.