this post was submitted on 12 Mar 2024
3 points (80.0% liked)

Home Server

412 readers
1 users here now

A community based around the building, set up, and use of home servers for a variety of purposes. All discussion is welcome!

founded 2 years ago
MODERATORS
[email protected]
3
Rate my rack ! (www.printables.com)
submitted 7 months ago by [email protected] to c/[email protected]
6 comments fedilink hide all child comments
 

I'm going to make this rack out of wood and angle iron I'm not going to put this many angle iron as most of my servers are 3U

Let me know if you spot something wrong

top 6 comments
sorted by: hot top controversial new old
[–] [email protected] 1 points 3 hours ago

Seems like a good idea, just test to see that it can take the weight before putting servers in it.

[–] [email protected] 2 points 7 months ago (1 children)

I'm not a rack designer, and I salute your idea, because it looks OK and is probably gonna work at least a bit, but I would be very careful with two things:

  1. As you add servers (weight) to it, the base support will likely collapse.
  2. As you add servers, the sides might "skew" and eventually make the whole assembly wobbly/unsafe. Normally, racks are either welded solid, or rely on transversal, lateral, and diagonal reinforcements.
[–] [email protected] 2 points 7 months ago (1 children)

Thanks, I will test it full of cinderblocks before putting in my server. Might add plywood or osb panels to the side if it need further reinforcements.

[–] [email protected] 1 points 7 months ago* (last edited 7 months ago)

Panels on the side, especially if screwed/bolted, are going to be pretty good for stability and overall robustness. An alternative to that would be metal braces, corners, etc. Specifically cross bracing.

I would suggest to look at existing designs for how to reinforce the angles. Also, there caveats specific to wood designs (wood fibres direction, proportions, shapes, wood type, quality, density, etc). You might want to ask on a woodworking specific forum.

[–] [email protected] 1 points 4 months ago (1 children)

Angle iron seems like a very poor choice. I'm assuming it's been chosen because it's "free".

How'd it work out? How'd the welding go?

[–] [email protected] 2 points 4 months ago

Not yet received, they will be 32" 1/16" aluminium angle screwed in the main posts