A place for Plumbers and those interested in Plumbing to ask questions and discuss the trade.
Community guidelines:
If you have a plumbing question please include a picture in your post.
If you have a question such as "does this look correct?" please include the code your area adheres to. If you're not sure please include state/province/country you're in. Codes can vary state to state and what's wrong in one area may be perfectly acceptable in another.
Just as codes vary, prices do too. That's why we won't discuss any pricing because there's so many factors that can't or shouldn't be conveyed to strangers over the internet.
Noticed a slow leak underneath my basement sink when the washing machine was draining. What are these pieces called (green arrows), and can I fix this leak myself? The leak is at the location where the metal-looking cylinder (which flexes a bit - probably plastic) enters the white nut-like thing at the P pipe (red arrow). I have fixed basic plumbing before. Or should I just call a plumber?
Not a plumber, but I'm a homeowner and have dabbled in DIY plumbing. If this is a kitchen drain, see if it's an intermittent issue. Plastic pipe joints can leak when they get overly hot (like when you drain pasta water and pour boiling water down the drain). If it's not a constant leak, just run cold water when you are draining very hot water.
The white plastic nut is part of the P trap assembly. The metal pipe is an adapter or nipple. The nipple should be seated against a seal inside the P trap, and the nut tightens them together. In your photo it doesn't look like the nut is threaded on very far, so it can't hurt to give it a turn. But if the nut is broken or the seal is waterlogged, it would need to be replaced.
If the drain isn't in constant use, I'd be inclined to remove it and bring to your home center. Otherwise, this photo would probably be what you need to identify the parts needed. The parts shouldn't be too costly.
The top most green arrow is the tailpiece, the bottom arrow is pointing at a slip joint nut with a reducing washer. You can buy replacement kits at most hardware stores for like 5 bucks.