this post was submitted on 20 May 2024
677 points (98.4% liked)

Cool Guides

4739 readers
1 users here now

Rules for Posting Guides on Our Community

1. Defining a Guide Guides are comprehensive reference materials, how-tos, or comparison tables. A guide must be well-organized both in content and layout. Information should be easily accessible without unnecessary navigation. Guides can include flowcharts, step-by-step instructions, or visual references that compare different elements side by side.

2. Infographic Guidelines Infographics are permitted if they are educational and informative. They should aim to convey complex information visually and clearly. However, infographics that primarily serve as visual essays without structured guidance will be subject to removal.

3. Grey Area Moderators may use discretion when deciding to remove posts. If in doubt, message us or use downvotes for content you find inappropriate.

4. Source Attribution If you know the original source of a guide, share it in the comments to credit the creators.

5. Diverse Content To keep our community engaging, avoid saturating the feed with similar topics. Excessive posts on a single topic may be moderated to maintain diversity.

6. Verify in Comments Always check the comments for additional insights or corrections. Moderators rely on community expertise for accuracy.

Community Guidelines

By following these rules, we can maintain a diverse and informative community. If you have any questions or concerns, feel free to reach out to the moderators. Thank you for contributing responsibly!

founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 18 points 7 months ago* (last edited 7 months ago) (3 children)

Clean everything with a board cleaner/alcohol.

Use a heat gun for the stubborn things.

Solder wick is fine, but if it's a through hole on a ground plane your going to be there a really long time.

Use the least amount of heat you can get away with.

Sometimes adding fresh solder on top of the old solder helps the heat spread so you can use the wick more effectively.

Constantly use fresh wick, and if it's really stubborn dip your wick in extra flux.

Desoldering guns are awesome, but a little spendy.

[–] Klajan 7 points 7 months ago

Massive Ground planes on a multi layer board were my breaking point.

I tried to clean the through holes where a micro USB port was secured and only could get it cleared by drilling out the solder.... (Only had a soldering iron and wick available)

[–] [email protected] 4 points 7 months ago

Adding fresh solder can also help if it's leaded / flux cored and the existing solder isn't

[–] [email protected] 2 points 7 months ago

I've done the rgb mod for an old NES. The PPU is on a big ground plane and just impossible to get off using a wick. Or you can, but now you've put so much heat into the chip that you fried it. Need a heat gun or hot plate.

Playstation SD card mod is easier than hand desoldering the NES PPU, and it involves scraping away very thin traces and soldering to them.