3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
The UI of Prusa slicer is hot garbage though. I started with prusa slicer and moved to orca after a few months. Orca is a much nicer experience, and the built-in test-models (temp towers etc.) are nice.
I'm comparing cura and prusa, so prusa wins by a lot. What are you comparing prusa to? Orca?
Yes
I give orca/bambu the edge for "prettier on screenshots", but in practice, I don't find their UI paradigm to be more efficient nor convenient.
In find the location and grouping of parameters more intuitive in orca. I always had to look through several tabs to find the parameter I wanted to adjust when I was using prusa, it was never where I thought it should be.