this post was submitted on 26 Jun 2024
175 points (97.8% liked)
Programmer Humor
18971 readers
882 users here now
Welcome to Programmer Humor!
This is a place where you can post jokes, memes, humor, etc. related to programming!
For sharing awful code theres also Programming Horror.
Rules
- Keep content in english
- No advertisements
- Posts must be related to programming or programmer topics
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
How you solder those without dropping a blob and causing a short is a mystery.
you flux the fluxing flux out of it
Tin the wire and the pin first and then touch the iron to them both quickly. They should stick fairly well without needing to add additional solder. Also, like someone else mentioned, flux can help quite a bit. (Maybe even a cupped soldering iron tip might be useful, depending on the situation.)
Learning how to solder SMD components will get you extremely familiar with how solder behaves at that scale. Let's just say it's significantly different than just doing basic wires and THT.
(Well, the solder doesn't really act different, but at smaller scales it looks like it does.)
I tried to hand-solder a Hirose .35-pitch connector onto a custom OSHPark board once. Let's just say it was a humbling experience. Thanks to a generous friend, I learned the value of solder masks and owning a home reflow oven.
Respect to whoever can do this sort of thing, but life is too damn short and my eyesight and hands don't need the abuse.