3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
Best I can tell, my z-seam after a hop is under extruding? I tried looking at all3dp's troubleshooting page, but couldn't find this specific issue. Can someone fill me in on the name of this so I can best Google it? I'd also be happy to take pointers, but I do try to be self sufficient.
That'll be your retraction settings that need to be tuned. The pressure inside the nozzle isn't getting high enough when starting a new layer. Took me a couple minutes to see the issue since it's black and shiny. I've used http://retractioncalibration.com/ before to help get my retractions tuned
Here's a pic of where it's happening on the outside which is much more obvious. It lines up precisely with the z-seam in the slicer. I think you might be right on retraction. Thanks for the resource!