OpenRGB

444 readers

4 users here now

The official Lemmy community for the OpenRGB project.

Official website: https://openrgb.org

GitLab: https://gitlab.com/CalcProgrammer1/OpenRGB

founded 3 years ago

MODERATORS

[email protected]

Recommendations for a Linux and OpenRGB-compatible A-RGB controller. (lemmy.world)

submitted 1 week ago* (last edited 1 week ago) by [email protected] to c/[email protected]

9 comments fedilink hide all child comments

I have been trying to figure out if i should get a better controller than the onboard controller on my ASRock motherboard.

The only problem is that it doesn't seem to support enough LEDs (or more than 5V/3A which is cutting it close) or direct mode.

I have been looking at the Razer Controller but the supported devices page and old Reddit posts seem to be torn on how good the support is in OpenRGB.

I mostly just need to get a working direct control since the direct control mode currently makes my ASRock motherboard unbootable (temporarily).

Any suggestions are welcome :)

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 1 points 6 days ago

It's just a matter of flashing the CorsairLightingProtocol firmware (instructions on the project's GitHub page) and then soldering the data pin of your LED strip to the appropriate Arduino pin. You can provide 5V power to the LEDs from a Molex or SATA power cable which allows as much power as your PSU can handle. You can draw 5V from the Arduino directly to run the LEDs but I would only run 30 LEDs or fewer with this power source. If you want more LEDs then connect them straight to your PSU.