this post was submitted on 18 Jun 2023
2 points (100.0% liked)

3D Printing

4 readers
2 users here now

A magazine dedicated to 3D Printing.

founded 1 year ago
2
Ender 5 Pro 2.0.6 bed doesnt lower the first 5-7 layers than will drop by like 5mm (kbin.social)
submitted 1 year ago by [email protected] to c/[email protected]
4 comments fedilink hide all child comments
 

like the title says i have an ender 5 pro and the bed is being weird. when i autohome it it works fine. but when i print the bed just stays at the top of the travel on the z axis for about the first 5-7 layers and then it will drop by over half a turn on the z stepper motor. leading to a large gap that cant be printed on. im using the latest creality slicer on standard settings if that helps any, maybe its a setting i havent turned off idk. id like to get this thing going as its been a few years since i got it and then i gave up.

you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 0 points 1 year ago (2 children)

...that is... so weird. So the bed just sits there up top.

Does the Z-axis motor just... sit there idle for those first 5-7 layers?

Does the Z-axis motor work smoothly after the inexplicable big jump? Does the plate move smoothly up and down other than that one area?

A couple of things I would do:

  1. This might be a firmware corruption issue on your printer. I have a 3 V2 not a 5 Pro, but you should still be able to reload the printer's firmware. I would definitely start with that.

  2. I don't think this will fix your problem though you never know: ditch creality slicer, it's just an older version of Cura and is missing some stuff. Get Cura instead. This will also give you the advantage of basically ignoring all your old slicer settings, giving you a fresh slicer start, so if it is a slicer thing, that should demonstrate that it is in fact a slicer thing.

[–] [email protected] 1 points 1 year ago (1 children)

seems like it was the wrong firmware. im just printing a simple flow test and its actually building on the z layer. thank you.

[–] [email protected] 2 points 1 year ago

oh hells yeah :D

congratulations and good luck on it continuing to work!

[–] [email protected] 1 points 1 year ago

yeah it just sits there not moving. its smooth and works fine otherwise, if i go to move z axis its fine up and down. but itll just sit there when im printing until about layer 5-7 and then it drops massively. ill try cura and flashing the firmware again. it makes no sense to me either.