3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
DIN912
DIN 7991
small plastic screws
square nuts
GB91 (split pins)
aluminium or copper tape (grounding/EMI-shield)
conductive foam (EMI grommet)
plastic glue (solvent) & cyanoacrylate
I personally prefer DIN 7380 over DIN 912 aesthetically, but of course 912 has superior mechanical properties.
7380 do come in handy as you can buy them with a spring washer and washer pre-installed.
If I care about aesthetics I use the DIN 7991 and dial in the tolerances to get it flush.