this post was submitted on 17 Jun 2023
2 points (100.0% liked)

3D Printing

4 readers
2 users here now

A magazine dedicated to 3D Printing.

founded 1 year ago
2
The question I’m sure was on everyone’s mind: can you combine PEI and glass beds? (solarbird.net)
submitted 1 year ago by [email protected] to c/[email protected]
13 comments fedilink hide all child comments
 

I like the thermal mass of glass for temperature stability, as I've found that's pretty key to getting good print adhesion. But I really wanted to try out PEI without having to stick a giant magnet directly to my heater plate, something I definitely did not trust.

Turns out, you can solve both problems! This was how I did it.

you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 1 points 1 year ago

I had a friend whose CR-10s I've subsequently adopted... (he wasn't all that into 3d printing, as it turns out.) when were getting started the glass build surface was absolutely terrible. (I kinda expected it would be. it was basically 1/8" picture frame glass. 3/16" or 1/4" boro or bust.)