this post was submitted on 11 Oct 2023
8 points (100.0% liked)

VoronDesign

305 readers
1 users here now

lemmy.world community for VoronDesign 3D printers

founded 1 year ago
MODERATORS
8
submitted 1 year ago* (last edited 1 year ago) by [email protected] to c/[email protected]
 

Hi!

Anyone has some experience with the Voron 2.4 kits from Formbot? Are they okay to begin with Voron designs or will I regret it?

Thanks!

you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 1 points 1 year ago (1 children)

I built one about a year ago and it's been great. At that point they didn't include a lot of the stuff they do now, so my SB/CW2, nevermore, chamber LEDs, etc. were sourced separately and I didn't use most of what they provided for the hot end

[–] [email protected] 1 points 1 year ago (1 children)

Ok! Thanks for the reply! What hotend did you installed instead?

[–] [email protected] 2 points 1 year ago (1 children)

I did the dragon HF, my kit came with whatever was before stealthburner and I bought an upgrade kit from 3dwest and went straight to that, so I never used the formbot fans and motor

[–] [email protected] 1 points 1 year ago

Alright! Thanks