this post was submitted on 16 Oct 2023
1760 points (99.3% liked)

internet funeral

6925 readers
2 users here now

ㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤart of the internet

What is this place?

[email protected] with text and titles

• post obscure and surreal art with text

• nothing memetic, nothing boring

• unique textural art images

• Post only images or gifs (except for meta posts)

Guidlines

• no video posts are allowed

• No memes. Not even surreal ones. Post your memes on [email protected] instead

• If your submission can be posted to [email protected] (I.e. no text images), It should be posted there instead

This is a curated magazine. Post anything and everything. It will either stay up or be lost into the void.

founded 1 year ago
MODERATORS
 
you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] -3 points 1 year ago (2 children)

Transistors are simple electronical devices. They don't run software.

No, as I just said in the comment you replied to, it's backwards. Software controls transistors.

The important difference is that a mechanical switch cannot be maliciously switched on by software. It has to be done physically and intentionally.

[–] [email protected] 2 points 1 year ago

There is absolutely no requirement that a transistor be controlled by software. They can be controlled by physical switches.

[–] [email protected] 1 points 1 year ago (1 children)

Transistors have no registers. They have no arithmetic logical units. They have nothing. They are so simple they can be made up of less than 100 atoms. Transistors have to be connected electrically to other device. Any reverse engineer can trace what it is connected to and it's behaviour cannot be programmed. If you know that it's a transistor and you know the inputs, you can know the output. The same cannot be said for a device which runs software, you'd have to additionally know what that software does, which is incredibly more complicated.

Software is ran by microcontrollers. Transistors can be connected to microcontrollers. But they can also be connected to buttons. If there is no microcontroller, there is no software.

[–] [email protected] -1 points 1 year ago (1 children)

I don't understand what any of that has to do with this conversation.

[–] [email protected] 1 points 1 year ago (2 children)

Well, you claim that transistors can be controlled by software, and I claim that it is no more capable to run software than a mechanical switch.

[–] [email protected] 0 points 1 year ago (1 children)

It's about as likely that the transistor is attached to a pin that sends an interrupt to the processor and it then applies a soft mute as it is the transistor is attached to a flip flop or register that toggles the mic getting power physically.

My guess would be it's controlled by software rather than directly by the hardware because then they can do whatever they want with the button via firmware or software updates. This includes nefarious stuff like a fake mute mode, or more innocent stuff like special behaviour on a long press vs short press.

[–] [email protected] 1 points 1 year ago

You could just connect the switch to an input pin on the processor. I don't see how a transistor makes this scenario more likely.

[–] [email protected] -2 points 1 year ago (1 children)

I don't know why you keep saying this so let me try for the third time:

A transistor does not run software, software runs transistors.

[–] [email protected] 1 points 1 year ago (1 children)

Please tell me. How exactly does software "run" a transistor?

[–] [email protected] 0 points 1 year ago (1 children)

The software is what decides when to send the signal to switch them on and off.

[–] [email protected] 1 points 1 year ago (1 children)

Now tell me, how does the software communicate with the transistor? Wifi? Bluetooth?

[–] [email protected] -1 points 1 year ago (1 children)

There is no "communication". Transistors don't have that capacity, they're just switches.