3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
Have you noticed that the crtouch has an extendable probe? The probe should be lower than the nozzle when homing or leveling (so the nozzle doesn't hit the bed) and higher than the nozzle otherwise (so the probe doesn't hit your prints.)
I found that auto bed leveling worked poorly on my Ender 3 S1, because the Z axis was not well-adjusted enough to make fine movements without binding. I reassembled all the Z axis stuff, making sure the eccentric nuts were just loose enough to not support any weight. You want almost all the gantry weight supported by the the Z axis screw(s), because downward motion is gravity-driven. If the Z screws have to "pull down" on the ganty, then the Z movement will be too sloppy for bed leveling to work.
Yeah, this was my assumption (the probe should hit before) - I just wasn’t sure if they were supposed to offset just enough with the adjustable probe to end up being in-line with the nozzle. The instructions are… not great.