3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
In addition to what has already been said, personally I use auto-home and then move the hot end to the middle of the bed (On my printer, after auto-home it is the ABL sensor that is in the middle of the bed) and then set the Z position to 0mm.
Then I go change the Z Offset setting until it touches the bed with the paper like you did.
In theory I suppose the result should be the same but it might be worth a try if what has been already suggested by u/p1mrx is not your problem.
Wait, sorry. What's supposed to touch the bed? The hot end or the ABL sensor?