3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
Can you describe the noise? Is it a high pitch whine, or a grinding sound?
It could be loose cable/connector for the stepper motor, as that can cause all sorts of strange sounds (usually of the grinding type).
If it's more a constant high pitch sound, it's likely the motors in use since they draw a lot of current to hold position (steppers work funny that way). This can be ignored safely, or reduce the motor peak amps to the motor to quiet the whine a bit (this usually involves modifying the firmware, and can be a bit more difficult sometimes.
Good luck
To add a little bit to this, check if the motor gets hot. If it's not hot then you probably don't need to worry.