Mechanic Advice

263 readers

12 users here now

This community is for getting help with vehicle or other mechanical problems.

Remember, there are no stupid questions, we want everyone to feel welcome. If you don't want to answer a question that you think is silly, then just move on and keep it to yourself.

Rules:

Don't be a dick

That is all.

founded 1 year ago

MODERATORS

[email protected]

06 tribute manual transmission clutch hard to press. (discuss.tchncs.de)

submitted 10 months ago by [email protected] to c/[email protected]

8 comments fedilink hide all child comments

All of a sudden my clutch went from totally normal to very hard to press down. It's now been this way for quite a long time. It's a hydraulic clutch (clutch was replaced by a shop a few months prior to the issue, but me and the shop....did not get along.) in an 06 tribute with a 4 cylinder motor.

Looking for what I'll need done in order to not have to break my leg to shift the thing. Thanks.

I figure it's something the shop didn't do correctly, as it was supposed to have new flywheel, pressure plate, clutch disc, pilot bearing and throw-out bearing but there's no way to verify they replaced it all or did it correctly and the problem started suddenly about 3 months later.

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 1 points 10 months ago

Could be a few things, clutch fork bent but let's pray not.

Have you adjusted it? My mentor's rule of thumb is to adjust new clutches after they're broken in, he hits them a week or so later if possible. I'd recommend it and have seen it happen quite a few times.

Could be clogged or pinched hydraulic lines. Bleeding the slave cylinder would be a start with that.

Check your clutch pedal, anything bent, broken etc?

Will get back with more. Am not an expert on clutches btw have just replaced quite a few. Not pretending to be an expert

Really hope it's not the fork though, that will do this but you'd have to drop the trans to replace it.