3DPrinting

15541 readers

184 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: [email protected] or [email protected]

There are CAD communities available at: [email protected] or [email protected]

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 1 year ago

MODERATORS

[email protected]

[Help] Looking for a 3D scan of a Utility Gas meter in Ontario. (lemmy.world)

submitted 11 months ago* (last edited 11 months ago) by [email protected] to c/[email protected]

22 comments fedilink hide all child comments

I am hoping someone may have the ability to scan the front and top of a utility gas meter that looks like the one above.

I would like the use this scan to model a front cover similar to the one shown in this link below, but suited for this type of meter.

https://www.thingiverse.com/thing:4845512

The purpose of this project is to hold a esp32 board to get consistent meter readings and feed them into home assistant. Here is the project below.

https://github.com/jomjol/AI-on-the-edge-device

Any help would be appreciated.

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 4 points 11 months ago

If you're already using an esp32 why not just get a simple ultrasonic sensor and measure flow on an indoor inlet pipe? You may need to know the pressure (probably 1.7 kPa) and temperature but that should be possible to calibrate against your meter readings

Then your project just becomes a simple pipe clamp that can be indoors