this post was submitted on 06 Nov 2023
17 points (100.0% liked)
3D Printing
4291 readers
1 users here now
For everyhting 3D printing related.
Please be excellent to each other :)
Icon by Freepik, Banner photo by Thiago Medeiros Araujo
founded 3 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Windex to clean, let it dry for a bit, then a layer of gluestick has always worked for me, as long as the bed heats to 60°C for printing. The z offset has to be a bit different for PETG than PLA, which can be a bit tricky. I think (been a whole since I've printed PETG) it had to be a bit higher than PLA, so it wouldn't "squish" as much as PLA. Seemed a bit counterintuitive, but it solved most of my problems