3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
Printed a simple soap tray- it was just a plate printed vertically- 3mm thick with rounded edges.
Prusaslicer settings were 1.5mm fuzzy skin with 2mm connection points, spiral mode with zero bottom infil, and a 3mm brim for adhesion. (The brim is easy to remove, and the edge looks nicer with with no infill.)
100%extrusion width.
Wash them. But it’s not going to turn moldy (it dries out quickly)