3DPrinting

15138 readers

14 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: [email protected] or [email protected]

There are CAD communities available at: [email protected] or [email protected]

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 1 year ago

MODERATORS

[email protected]

[troubleshooting] Adhesion issue (imgur.com)

submitted 6 months ago* (last edited 6 months ago) by [email protected] to c/[email protected]

10 comments fedilink hide all child comments

I am somewhat new to 3d printing and i am playing around with different filaments and print plates on my cheap ender3 v3 se.

Right now I am observing a weird adhesion-issue i have not seen before: The copper-silk filament has trouble sticking to the printplate, but only in some places of the plate.

My guess it's either some dirt/oil on the printplate. Or maybe the silk-pla has bad adhesion.

What do you think?

This printplate is this (but glued over the original printplate): https://www.amazon.de/dp/B0CL5FYHBR

The filament is this: https://www.amazon.de/dp/B09CPBRQXS

some clarification for the video: all corners of the first layer should have been rectangular. Instead some corner lost adhesion and become roundish. Here is the view from the slicer: https://imgur.com/rwA0fQW

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 8 points 6 months ago* (last edited 6 months ago) (2 children)

Try increasing hotend temp for first few layers and hotbed temp throughout
Try moving z closer for first layer
Repeat both of above in small increments

FWIW, those PEI sheets usually need higher bed temp than the regular sheets

[–] [email protected] 2 points 6 months ago (1 children)

Try increasing hotend temp for first few layers and hotbed temp throughout

the default from the printer was 60C. I had some better results with 70C. But the issue still happend with more delicate prints.

those PEI sheets usually need higher bed temp than the regular sheets

thanks. I didn't know that. What magnitude are we talking here (like: 10K more for PEI-sheets? or more like 1K?)

Try moving z closer for first layer

I think this may be the solution. How much should I change the z-offset? (the print in the video has 0.2mm layer height. And the worst-adhession issues happened with 0.1mm)

[–] [email protected] 5 points 6 months ago

K Kelvin, not K thousands of degrees... It's too early to think.

You may also have a bed flatness problem, if it's not a dirty plate.