3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
I have every setting turned all the way up speed/accel/jerk is only limited by the power limits on the steppers. In the firmware speed is set at 300mms same with on prusa slicer. I just added zeros to the accel and jerk both in firmware and in the slicer. It's an ender 3 with an skr V2 Rev b board and a generic 2 into 1 hotend.
I'm not a huge fan of the way the documentation reccomends you test for the ringing. They basically change the tune +x amount every layer and you pick the best looking layer. Thus you know what cancelation frequency works. This is subjective. I prefer the klipper style where you actually measure the ringing in the print and enter the length of x rings per x mm over y speed.