this post was submitted on 17 Jun 2023
1 points (100.0% liked)

3D-printed Gaming

334 readers
1 users here now

The very beginning of a great collaboration, full of 3D-printing hobbyists, pros, gamers, and fans of all genres across the board. No politics, religion, or spam, please. Let's make this THE place to come to for amazing prints, awesome paintingjobs, printing requests, design ideas, and so much more!

founded 1 year ago
MODERATORS
 

Only two more full print plates (Jupiters) to go, and the rear half of the torso and the big wings will be ready for post-proc & shipping! (The Bahamut medallion there is โŒ€ 50mm, btw.) Then, we're onto a 200% Bahamut, by Lord of the Print โ€” which will stand over 2ft tall and nearly 3ft wide, wingtip to wingtip. ๐Ÿ˜ฑ

Lesson learned: Each full plate of these upscaled sculpts run about 1L of resin, so I'll be updating the pricing for the 150%+ versions. ๐Ÿคฃ๐Ÿคท๐Ÿผโ€โ™‚๏ธ

no comments (yet)
sorted by: hot top controversial new old
there doesn't seem to be anything here