The top layer curl is something I've experienced on 3 different printers so far, to varying degrees. I think it's caused by a very light partial clog. I switch out the nozzle to fix it normally, but the pattern has grown on my for general use. I just think it looks kinda neat.
GoldenSpamfish
joined 1 year ago
this is cool, but kinda overkill. I just printed a super simple insert that fits snugly into the spole hole and the problem went away completely.
I go through 3-4 spools a month so carboard has been huge for me.
what's the best way to post videos on lemmy? Know a good hosting site? Also, I'm working through filament pathing issues right now so it's not going as fast as it could be.
Considering you can freeze a whole mouse and have them survive after unfrozen, but not a human, I wonder how well this will carry over.
I think allowing only discussion of how to set up lemmy instances via command line would make sense.
this is the least offensive cube rule example you could have posted tbh.
why do zero cross instance links work in jerboa
I would really hope your printer can produce radii to 1mm tolerance. Especially for the higher end of sizes.
Filamentum TPU 98A is probably the toughest filament you can buy. If you are ok with a little bit of flex, it's basically impossible to break any parts made with this stuff.
Oh so that's what AWD is? Sounds cool. For me though, my issue is probably down to belt tension.
I really do need to sort this out because I keep running into it on different machines (even ones I don't maintain myself, like in labs), but I can't find anything about it on the internet. last time I made a post about it nobody knew what was causing it, but a nozzle swap has normally fixed it.