CyberDeck

249 readers

1 users here now

Hey y'all, just an experiment, if it works out I'll clean it up and run it

founded 2 years ago

MODERATORS

[email protected]

195

Made my own laptop/cyberdeck after months and months of trying (lemmy.world)

submitted 2 months ago by [email protected] to c/[email protected]

32 comments fedilink hide all child comments

Still needs some design corrections because I just didn't know how to properly do 3D print and industrial design but it works!

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 1 points 2 months ago* (last edited 2 months ago)

So that's a problem at the moment. I am using Orange pi 5 plus which is an arm processor and it doesn't get hot by default, plus there's a fan and heat sink on it, so I didn't put any exhaust holes for aesthetics, but now it turns on the fan every a few minutes for a minute because it gets too hot in there plus the ssd nvme is generating a lot of heat. it's running in about 58°c which is alright but I'm planning to add a small fan and some exhaust holes for the next version.