3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)
Moderation policy: Light, mostly invisible
view the rest of the comments
You can test this with a simple set of pins and a hollown tube to fit. In anything that lets you define parameters, just set the pins to something like [diameter] - .01x[1, 2,3,4, etc]
The other tip here is to make the parts slightly trapezoidal in cross section, so they start easy and only really pressfit tightly the last bit,
Edit: it’s different for every printer, even printers of the same brand. It depends a lot on how well tuned it is, and just what the total dimensional consistency is between prints.
Thats a very fair point. I've done tolerance tests with mine and can get away with 0 with some encouragement and .05 just fine. Thanks!
Yeah, gotta be careful with tolerances from others… speaking from experience.
More, uh, “experience” than I care to admit.