3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
It kind of depends on where you are. if you're someplace dry, you may not even need that much.
for PLA, I've found a session in the dehydrator (and recharge the packs at the same time!) is enough to keep it just fine... in a gallon size ziplock. and many PLA brands don't necessarily need to be dried (oh, you'll get zitting, for sure. And it can be brittle from the steam getting forced out if it's been open for a while.)
PETG and TPU need more, because they'll soak up any moisture they can.