this post was submitted on 07 Dec 2023
46 points (96.0% liked)

Ukraine

8301 readers
574 users here now

News and discussion related to Ukraine

*Sympathy for enemy combatants is prohibited.

*No content depicting extreme violence or gore.

*Posts containing combat footage should include [Combat] in title

*Combat videos containing any footage of a visible human must be flagged NSFW

Server Rules

  1. Remember the human! (no harassment, threats, etc.)
  2. No racism or other discrimination
  3. No Nazis, QAnon or similar
  4. No porn
  5. No ads or spam
  6. No content against Finnish law

Donate to support Ukraine's Defense

Donate to support Humanitarian Aid


founded 2 years ago
MODERATORS
top 14 comments
sorted by: hot top controversial new old
[–] [email protected] 16 points 11 months ago* (last edited 11 months ago) (1 children)

As a helicopter mechanic, this may not look like a lot, but I can 100% guarantee that the entire helicopter is a write off with that dammage. You would have to rip apart the entire helicopter and put it back together with a bunch of brand new parts for it to be safe again. This at the very least is a total refit requirement. Or some Russian pilots can go die after they did not realize one of those balls embeded itself in the transmission, either works.

[–] [email protected] 12 points 11 months ago (1 children)

"Best I can do is a roll of aluminum tape and an inexperienced pilot. We fly at dawn!"

[–] [email protected] 1 points 11 months ago

Rofl.. thanks for this comment.

[–] [email protected] 7 points 11 months ago (1 children)

I'm sure all the electronic boards, tubing for hydraulics, etc just love having little holes punched through them.

[–] [email protected] 0 points 11 months ago (3 children)

I don't know if I'm blind, but I'm not seeing too many holes?

Back during ww1 or ww2 they figured out that the planes that came home with many holes in them, didn't take catastrophic damage and instead reinforced where there weren't holes.

So it's hard to know if these holes are catastrophic or not

[–] [email protected] 9 points 11 months ago (3 children)

I don’t know if I’m blind, but I’m not seeing too many holes?

Are you looking at the full sized pictures or the shrunk ones? Here's just one with the holes see circled in red:

[–] [email protected] 4 points 11 months ago* (last edited 11 months ago)

Oh damn ya I was looking at the smaller zoomed one. I tried to see if I was doing something wrong even but failed at that. Thanks, much appreciated.

[–] [email protected] 3 points 11 months ago

Holy shit ha ha ha, that's not going to fly ever again lol.

[–] [email protected] 2 points 11 months ago

You are cheating by counting each entrance hope at the top and exit hole at the bottom separately..... /s

[–] [email protected] 5 points 11 months ago (1 children)

It was WW2. WWI planes did not get armour. They were made typically of wood and canvas and used engines with the same output as a moped. Also, the example you provide is for planes that were hit in mid flight and lived to RTB for examination. This helicopter was hit on the ground and abandoned. Assuming any of the holes aren't catastrophic would be a dire mistake.

[–] [email protected] 1 points 11 months ago (1 children)

you are wrong on the ww1 fighter engines unless you think 100hp+ is typical for mopeds

@Burstar @NotMyOldRedditName @ukraine

[–] [email protected] 4 points 11 months ago

Well, at least I understand what hyperbole is.

[–] [email protected] 3 points 11 months ago (1 children)

The survival bias diagram you usually see for this is not necessarily for a single plane but for a number of them and aggregated into the diagram you’re familiar with.

[–] [email protected] 1 points 11 months ago

Also, this was for planes that returned home. IE they could still fly.
If they were hit like that on the ground, they would probably be written off. Cause it would be an unknown possible death sentence.