Physical destruction. It's the only way to be 100% sure.
Nuke it from orbit. Only way to be safe
⬆️➡️⬇️⬇️⬇️
A fellow enjoyer of democracy
*Presses b
A fellow Expeditionary Force enjoyer I see
For secure data destruction, either pay for it to be done properly, or create your own way of doing it. A decent sized drill bit can do all the work for you, at the cost of a new drive of course.
A special feature known as SSD secure erase. The easiest OS-independent way is probably via CMOS setup – modern BIOSes can send secure erase to NVM Express SSDs and possibly SATA SSDs.
Did this already, it took 1 second for a 2TB drive. Would you trust that?
Most SSD/flash secure erase methods involve the storage having full disk encryption enabled, and simply destroying the encryption key. Without the encryption key the data can't be deciphered even with the correct password, as the password was only used to encrypt the encryption key itself. This is why you can "factory reset" an iPhone or Android in seconds.
It is the only approved method for data destruction for the several banks and government agencies I support. If they trust it, I trust it.
I have checked a couple of times out of curiosity, after a secure erase the drive is as clean as if it had been DBANed. Sometimes things are standards because they work properly.
Yes. SSDs are different from HDDs.
Call the devices secure erase functionality.
here’s how to do it to sata and pata devices
I don’t do some of the checking and testing in that article, I just do —security-erase-enhanced and unless it fails it’s fine.
You could also encrypt the contents and delete the key.
This is the correct answer. Due to wear levelling, a traditional drive wipe program isn't going to work reliably, whereas most (all?) SSDs have some sort of secure erase function.
It's been a while since I read up on it but I think it works due to the drive encrypting everything that's written to it, though you wouldn't know it's happening. When you call the secure erase function it just forgets the key and cycles in a new one, rendering everything previously written to it irrecoverable. The bonus is that it's an incredibly quick operation.
Failing that, smash it to bits.
And if you're hiding from a nation state ... don't trust that, smash it to bits and dispose of them at different trash collection locations 🙂
Are you considering using the drive afterwards? Because “toss it in a microwave for like 5 minutes” is always a valid answer if you’re not worried about reusing it.
For all average user requirements that just involve backups, PII docs, your sex vids, etc (e.g. not someone who could be persecuted, prosecuted, or murdered for their data) your best bet (other than physical destruction) is to encrypt every usable bit in the drive.
$-963,;@82??/@;!3?$.&$-,fysnvefeianbsTak62064$@/lsjgegelwidvwggagabanskhbwugVg, copy it, and close/delete without saving.Even if veracrypt hits a free space error at the end of the task, the job is done. Maybe not 100%, but 99.99+% of space on the SSD is overwritten with indecipherable gibberish. Maybe advanced forensics could recover some bits, but a) why the fuck would they go to that effort for a filthy commoner like yourself, and b) what are the chances that 0.01% of recoverable data contains anything useful!?! You don't really need to bother destroying the header encryption key (as apple and android products do when you wipe a device) as you don't know the password and there isn't a chance in hell you or anyone else is gonna guess, nor brute force, it.
This article covers several methods. Personally, I'd look for a BIOS based tool first, as that would be free and easiest. After that, the Diskpart Clean All command is probably fine for anything other than Top Secret data which a government based threat actor would be willing to put a lot of resources into recovering. If it's just your tax documents and porn archive, no one is going to care enough to dig out anything which that command might have left behind.
A microwave oven should do the trick
I hear thermite is good at destroying things.
i know this isn't what is being asked, but disk level encryption is cool
NSA requires the use of a industrial shredder that can grind the components into pieces less than 2mm.
https://ameri-shred.com/portfolio-items/2mm-ssd-solid-state-drive-hammer-mills/
If you can't do that, you should incinerate the drive at over 700 degrees.
As far as wiping goes, a 3 pass overwrite alternating 0s and 1s is good enough as long as it's done over the entire drive, not just the partition.
BCWipe is good enough for this
doesn't just overwriting the data work?
No. Modern SSDs are quite sophisticated in how they handle wear leveling and are, for the most part, black boxes.
SSDs maintain a mapping of logical blocks (what your OS sees) to physical blocks (where the data is physically stored on the flash chips). For instance, when your computer writes to the logical block address 100, the SSD might map that to a physical block address of 200 (this is a very simplified). If you overwrite logical block address 100 again, the SSD might write to physical block address 300 and remap it, while not touching the data at physical block address 200. This let's you avoid wearing out a particular part of the flash memory and instead spread the load out. It also means that someone could potentially rip the flash chips off the SSD, read them directly, and see data you thought was overwritten.
You can't just overwrite the entire SSD either because most SSDs overprovision, e.g. physically have more storage than they report. This is for wear leveling and increased life span of the SSD. If you overwrite the entire SSD, there may be physical flash that was not being overwritten. You can try overwriting the drive multiple times, but because SSDs are black boxes, you can't be 100% sure how it handles wear leveling and that all the data was actually overwritten.
No, "overwritten" data doesn't actually get erased right away due to wear levelling. As SSDs get esoterically smart with how they prevent unnecessary erase operations, there's no way to be sure without secure erase.
If it's really sensitive shit, you should beat the shit out of it with a sledgehammer and make sure you got all the nand modules(see diagram online), then throw parts of it into a large body of water, deeper the better
Smash it to pieces, melt it down into a blob and drop it down a borehole at the nearest quarry
So many people here responding with outdated misinformation.
Whoever might need, for whatever reason, to write on a parchment sheet which had already been written, should take some milk and should put the parchment in it for one night’s time. As soon as it is taken out, it should be strewn with flour in order that it not be wrinkled after it begins to dry, and so as to be kept under pressure until it dries out. After it is done, the parchment will regain its former quality, shining and lucid, by means of pumice stone and chalk.
What about phones?
Bench grinder, sledgehammer, and thermite all work on phones too!
A loosely moderated place to ask open-ended questions
If your post meets the following criteria, it's welcome here!
Looking for support?
Looking for a community?
~Icon~ ~by~ ~@Double_[email protected]~