In other news, if you try to upload a file named uncalibrated_example.stl to Thingiverse, it fails with no error message, because somewhere they have a pr0n filter searching for rated*x.

Some people might find this bundle_scad.py code useful. It combines an STL, SCAD, and all its dependencies into a single file.

I have one of these J3400 to J1772 adapters so I can connect my Hyundai to a Tesla destination charger. They'll probably get more popular as J3400 becomes the primary standard:

I'm curious what would actually happen if someone were to use such an adapter with a J3400 DC fast charger. I know it can't possibly work because the DC charging pins are connected to the vehicle's AC pins, but is there something in the J3400 standard to notice and reject such an adapter before DC voltage is applied?

I'm not sure if J1772 vs. CCS1 adapters contain anything that the signalling protocol could use to identify which is which. If the DC charger were required to passively measure the battery voltage before sending any power, that would probably avoid the "magic smoke" problem, but does the standard guarantee that this will happen?

I designed this wonky-looking funnel to fit my Squirrel Buster Legacy (and probably similar models), with hooks and posts that make it possible to refill the feeder without setting any parts on the ground.

This design of feeder needs to be located away from surfaces that a squirrel could stand on, so I assume a lot of people run into this problem. I don't really blame the company for making it so cumbersome to operate, because there's overlap between the smartest squirrels and the dumbest humans.

I think I found a counterexample to the common wisdom that more walls always create a stronger part.

The pictured S shape is 1.5mm thick, so printing with 2 walls leaves no room for infill. My testing wasn't very rigorous, but it seems that the hybrid structure of walls + rectilinear infill is 10-20% more rigid than walls alone. The infill adds strength by cris-crossing between adjacent layers.

I think it's fine to include a concentric top/bottom layer, but multiple identical layers weaken the part. I also tried 0 walls (infill only) and that was garbage.